How to apply XF-7 Weapons Grade Gun Lubricant

XF7 must be applied to a clean and dry surface for best results.

DO NOT APPLY IT OVER ANY LUBRICANT RESIDUE OR FOULING as this may prevent XF7 from coating the metal substrate.  Other lubes may be applied over XF7, but they may also affect the coating and performance of the XF7.  

Before applying XF7, prep metal surfaces by washing with warm soapy water and drying thoroughly, or by chemically degreasing.
  • Shake Liquid Well Before Use
  • Spray On A Wash Cloth and let mixing agent evaporate, Use as an applicator.  Great for applying to exterior of gun.
  • Liquid is great for getting in those hard to reach areas such as lever actions, AR-15 Stars, trigger assemblies
  • Syringe is best used for larger area applications such as gun exteriors, handgun rails, under side of slides.  

Apply XF-7 From A Syringe

To apply XF7 lubricant™ grease, squeeze out a small amount from the syringe or tube onto the surface to be protected.  Rub it on the surface area thoroughly with your finger, a patch, or brush until only a visible thin film remains.
Remember a great advantage of XF-7 Lubricant is the ability to be effective with small amounts, Leaving more in your wallet.

Apply XF-7 Liquid

  • XF-7 Spray is unique by offering a liquified grease.  
  • It is the exact same grease that is found in our syringes.  
  • The  mixing agent that it is mixed with will evaporate after spraying
  • This leaves a thin layer of grease where it was sprayed.  There is no need to wipe off.  
  • Simply spray and walk away.  
  • Shake well before use

XF7 Lubricant can be used to prevent corrosion in gun bores, but care must be taken to remove all excess lubricant.  For best results, run a patch lightly coated with XF7 Lubricant spray only once through a clean bore, going breach to muzzle.